SHOP ONLINE - YOUR SEAL SEARCH ENGINE

Surface Finish


Surface Finish

cast-surface-finishAs shown in Table 8 the surface finish of a casting will vary greatly depending on the process being used. An investment cast part will yield about a 125 μinch RMS surface, a die cast part about a 64 μinch RMS surface while a sand casting will be around 500 μinch RMS.

The surface finish will be modified in areas where a gate or riser has been removed. This can be a broken area where the gate was snapped off or a ground/cut surface where the gate was removed.

The surface finish in all casting processes can be modified through out the part by shot or bead blasting if needed but adds cost to the final part.


Parameters Affecting Sealing:

Need Help? Ask Us A Question

*required fields

Name*

Email*:

Phone:

File Upload (please limit file size to 3 megabytes)

Question or Comments